Porshe 911 (997). Manual - part 738

 

  Index      Hummer     Porshe 911 997 series - service repair manual 2004-2008 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  736  737  738  739   ..

 

 

Porshe 911 (997). Manual - part 738

 

 

risulti perfetta, durante la stampa venga persa la corrispondenza fra testo e
relativa immagine.
Se tale difetto non viene rilevato vi è il pericolo che i lavori non siano eseguiti
correttamente; ciò può avere come conseguenza lesioni e danneggiamenti.

• 

→ Per questo motivo, dopo la stampa è assolutamente necessario confrontare le stampe con la
rappresentazione sullo schermo. In caso di errore si prega di correggere le stampe, così da
garantire la riproduzione esatta della rappresentazione sullo schermo.

ADVERTENCIA

Al imprimir se corre el riesgo de perder la correcta asignación de las figuras al texto.

Por motivos técnicos, por el momento no se puede descartar que, aun siendo
correcta la imagen que aparezca en la pantalla, al imprimir se pierda la
correlación entre el texto y la figura correspondiente.

• 

Si este error pasara desapercibido, existe el riesgo de que los trabajos no se
ejecuten de forma correcta y, por tanto, se produzcan daños personales y
materiales.

• 

→ Por ello le rogamos que tras el proceso de impresión compare siempre las copias impresas con
la imagen de la pantalla. En caso de error, corrija las copias impresas de forma que se
correspondan con el contenido de la imagen de la pantalla.

Diagnostic system: reading out fault memory and activating systems

Installing rear roof trim panel

3109

- Preliminary work
- Removing slide/tilt sunroof trim
- Installing slide/tilt sunroof trim
- Subsequent work

Preliminary work

Preliminary work

Removing sliding-roof panel → 604019 Removing and installing sliding-roof panel - chapter on "Removing"

Removing slide/tilt sunroof trim

Removing slide/tilt sunroof trim

Installation Location:

Installation position for slide/tilt sunroof trim

3110

Positioning slide/tilt sunroof trim

1. Position the slide/tilt sunroof trim -dimension X- approx. 80 mm in front of the roof edge cut-out.

Removing slide/tilt sunroof trim

2. Disengage left and right inner side panels. Pull out the connector springs -A- on the gate and carefully pull

the slide/tilt sunroof trim upwards.

Installation Location:

Diagnostic system: reading out fault memory and activating systems

Removing slide/tilt sunroof trim

3111

Installation position for slide/tilt sunroof trim

Note

The inner panels must be removed or replaced if the sliding roof panel and slide/tilt sunroof trim is
removed and the gate of the roof frame is extended (tilting position).

• 

Removing inner panel

1. Push the sides of the inner panels out of the sliding roof frame inwards (centre of the

vehicle).

Installing slide/tilt sunroof trim

Diagnostic system: reading out fault memory and activating systems

3112

 

 

 

 

 

 

 

Content   ..  736  737  738  739   ..