Porshe 911 (997). Manual - part 680

 

  Index      Hummer     Porshe 911 997 series - service repair manual 2004-2008 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  678  679  680  681   ..

 

 

Porshe 911 (997). Manual - part 680

 

 

Pericolo di perdita dell'abbinamento testo-immagine nella stampa.

Per motivi tecnici non è escluso che, nonostante la rappresentazione sullo schermo
risulti perfetta, durante la stampa venga persa la corrispondenza fra testo e
relativa immagine.

• 

Se tale difetto non viene rilevato vi è il pericolo che i lavori non siano eseguiti
correttamente; ciò può avere come conseguenza lesioni e danneggiamenti.

• 

→ Per questo motivo, dopo la stampa è assolutamente necessario confrontare le stampe con la
rappresentazione sullo schermo. In caso di errore si prega di correggere le stampe, così da
garantire la riproduzione esatta della rappresentazione sullo schermo.

ADVERTENCIA

Al imprimir se corre el riesgo de perder la correcta asignación de las figuras al texto.

Por motivos técnicos, por el momento no se puede descartar que, aun siendo
correcta la imagen que aparezca en la pantalla, al imprimir se pierda la
correlación entre el texto y la figura correspondiente.

• 

Si este error pasara desapercibido, existe el riesgo de que los trabajos no se
ejecuten de forma correcta y, por tanto, se produzcan daños personales y
materiales.

• 

→ Por ello le rogamos que tras el proceso de impresión compare siempre las copias impresas con
la imagen de la pantalla. En caso de error, corrija las copias impresas de forma que se
correspondan con el contenido de la imagen de la pantalla.

Diagnostic system: reading out fault memory and activating systems

Calibrating steering-angle sensor

2877

- General warning notes
- Removing driver's airbag unit
- Installing driver's airbag unit
- Reworking

Preliminary work for driver's airbag unit

Note

Operate the steering wheel with the battery disconnected. Before disconnecting the battery, observe the
following points:

1. Insert ignition key into ignition lock, switch on ignition and then off again.

2. Leave ignition key

inserted.

3. Disconnect battery. →   Work instructions after disconnecting the battery

General warning notes

General warnings for driver's airbag unit

WARNING

Incorrect triggering of airbag module.

Danger of injury and damage to property as a result of incorrect handling of airbag units!

• 

→ The safety regulations →   Safety regulations for handling airbag and belt tensioner units must be

followed.

→ The airbag unit must always be stowed so that the airbag opening faces upwards!

→ If removed for an extended period, the airbag unit must be kept in a locked place!

→ Remove ignition key. Disconnect battery. Route or isolate ground strap so that all contact with a ground

carrier (e.g. body, seat frame) is avoided.

→ After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.

2878

ATTENTION

Incorrect release of airbag unit.

Danger of injury and material damage if airbag units are not installed correctly!

• 

→ Before installing the airbag unit, check whether the locking clip, the airbag unit mounting and/or the metal

stop on the steering wheel are deformed. If there is deformation, replace the damaged component (steering
wheel/airbag unit).

→ The airbag unit must only be installed with locking clips that are operational and are in the correct

position.

→ The locking clip must not jam or grind.

→ Do not expose face and other parts of the body to the airbag unit.

Removing driver's airbag unit

Removing driver's airbag unit

Installation Location:

Overview of driver' airbag unit

Diagnostic system: reading out fault memory and activating systems

General warnings for driver's airbag unit

2879

Releasing driver's airbag unit

1. Turn steering wheel 90° and stick a T30 (Torx with handle) or medium-size screwdriver through the

opening of the steering wheel.

WARNING

Incorrect triggering of airbag module.

Danger of injury and damage to property as a result of incorrect handling of airbag units!

• 

→ The safety regulations →   Safety regulations for handling airbag and belt tensioner units must be

followed.

→ The airbag unit must always be stowed so that the airbag opening faces upwards!

→ If removed for an extended period, the airbag unit must be kept in a locked place!

→ Remove ignition key. Disconnect battery. Route or isolate ground strap so that all contact with a ground

carrier (e.g. body, seat frame) is avoided.

→ After the battery is disconnected, always wait for 1 minute before disconnecting the airbag plugs.

Incorrect triggering of airbag module.

2. Use the screwdriver or T30 to compress the locking clip and pull the airbag unit from the steering wheel

with the fingers.

Diagnostic system: reading out fault memory and activating systems

Removing driver's airbag unit

2880

 

 

 

 

 

 

 

Content   ..  678  679  680  681   ..