|
|
Installing the sensor plug connection 2. Push on the electrical connector until it clicks into place. Engaging the support 3. Position the support and engage in lower side member. Installing the support 4. Clip in locating peg -1- and check it is seated correctly. 5. Tighten the plastic fastening nuts -3- . 6. Screw in fastening screws -2- . → Final tightening: 7.2 (5.5) Nm(ftlb.) 7. Lay the floor covering over the support and engage. Reworking Diagnostic system: reading out fault memory and activating systems Installing sensor for centre airbag 2857 |