Porshe 911 (997). Manual - part 512

Installing water drip pan

Installing water channel

Installation Location:

Installation position of water drip pan

ATTENTION

Danger of injury! Sharp-edge burrs on body and unit parts!

Danger of injury from sharp edges on body and unit parts!

• 

→ Wear protective gloves when working in the area of sharp-edged body and unit parts!

Applying adhesive

Note

Diagnostic system: reading out fault memory and activating systems

 Installing water drip pan

2205

Sealing surface of water channel and inner wheel arch must be clean and free of grease.

1. Apply approx. 10 mm of adhesive -1- → SEALING MATERIAL along the inner wheel

arch.

Installing water channel

2. Position water channel on the body and screw it on tight with the fastening nut -2- . Tightening

torque → Tightening torque: 7 (5 ftlb.) Nm

3. Press in clamp

-1-

 .

Spreading out adhesive

4. Spread out any adhesive emerging at the sides -1- with a brush -2- .

5. Patch new sealing face and damage to top-coat paint with the same colour as the

vehicle.

Diagnostic system: reading out fault memory and activating systems

Installing water channel

2206

Securing sound absorber

6. Secure sound absorber -2- to inner wheel arch -arrow A- and screw in cable holder -1- ( -arrow B- ).

Installing water drip pan

Installation Location:

Installation position of water drip pan

Installing water drip pan

1. Guide water drip pan -1- into position from above -arrow A- and insert into water drain tube at the

bottom -2- ( -arrow B- ).

2. Press in plug -3- .

3. Position support -4- on water drip pan -1- and screw fastening screw -5- in but do not

tighten.

4.

Diagnostic system: reading out fault memory and activating systems

Installing water drip pan

2207

Adjust support -4- . → 610115 Adjusting
convertible top

5. Tighten fastening screw -5- . Tightening torque → Tightening torque: 23 (17 ftlb.) Nm

6. Press in seal for convertible-top compartment lid close to the water

drip pan.

Subsequent work

Subsequent work

Install convertible top. → 610119 Removing and installing convertible top - section on "Installing"

997310, 997311, 997320, 997321, 997610, 997611, 997620, 997621

WARNUNG

Gefahr des Verlusts der Text-Bild-Zuordnung beim Ausdruck.

Aus technischen Gründen kann derzeit nicht ausgeschlossen werden, dass trotz
einwandfreier Darstellung auf dem Bildschirm beim Ausdruck der
Zusammenhang von Text und zugehörigem Bild verloren geht.

• 

Wird der Fehler nicht bemerkt, besteht die Gefahr, daß Arbeiten nicht korrekt
durchgeführt werden und es dadurch zu Personen- und Sachschäden kommt.

• 

→ Vergleichen Sie deshalb nach dem Druckvorgang unbedingt die Ausdrucke mit der
Bildschirmdarstellung. Korrigieren Sie die Ausdrucke im Fehlerfall so, daß der Inhalt der
Bildschirmdarstellung zutreffend wiedergegeben wird.

WARNING

Danger of losing text-figure correspondence when printing out.

For technical reasons, it can currently not be ruled out that the correspondence
between text and associated figure can be lost when it is printed out, even though
the display on the screen is correct.

• 

If the fault is not noticed, there is the danger that work will not be performed
correctly which can cause injury and damage.

• 

Diagnostic system: reading out fault memory and activating systems

 Subsequent work

2208