Porshe 911 (997). Manual - part 510

 

  Index      Hummer     Porshe 911 997 series - service repair manual 2004-2008 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  508  509  510  511   ..

 

 

Porshe 911 (997). Manual - part 510

 

 

Installing the rear hardtop locking element

Installing rear hardtop locking mechanism

Installation Location:

Installation position of rear hardtop locking mechanism

Installing rear hardtop locking mechanism

Note

Only for removal of the rear left hardtop locking mechanism.

1. Position hardtop locking mechanism -2- on the hardtop body and screw down with the fastening

screws -3- . Tightening torque → Tightening torque: 10 (7.5 ftlb.) Nm

2. Screw in fastening screw -1- for rear hardtop locking mechanism by hand and then tighten to

specified tightening torque → Tightening torque: 46 (34 ftlb.) Nm .

Diagnostic system: reading out fault memory and activating systems

 Installing the rear hardtop locking element

2197

Clipping in trim panel

3. Check fastening clips, replacing if necessary. Clip in trim panel -1- .

Fitting wiring harness for the rear window heating

Note

Only for removal of the rear left hardtop locking mechanism.

4. Rivet flat plug -2- of wiring harness with a 3.2 mm tubular rivet -3- to the hardtop body -1- and connect

the electric plug connection for the rear window heating -4- .

Clipping in lining at the sides

Note

Only for removal of the rear left hardtop locking mechanism.

Note

Once a trim panel has been clipped in, the old plastic clips are no longer usable and must always be
replaced.

• 

Diagnostic system: reading out fault memory and activating systems

Installing rear hardtop locking mechanism

2198

5. Clip in lining -2- at the sides to the hardtop body -1- .

Installing support for centring peg

Note

Only for removal of the rear left hardtop locking mechanism.

6. Insert support for centring peg -2- and tighten with fastening screw -1- . Tightening torque →

Tightening torque : 10 (7.5 ftlb.) Nm

Subsequent work

Subsequent work

Note

Only for removal of the rear left hardtop locking mechanism.

1. Install hardtop. → 610219 Removing and installing hardtop - chapter on "Installing"

2. Adjust hardtop. → 610215 Adjusting hardtop - chapter on

"Adjusting"

997310, 997311, 997320, 997321, 997610, 997611, 997620, 997621

WARNUNG

Gefahr des Verlusts der Text-Bild-Zuordnung beim Ausdruck.

Diagnostic system: reading out fault memory and activating systems

 Subsequent work

2199

Aus technischen Gründen kann derzeit nicht ausgeschlossen werden, dass trotz
einwandfreier Darstellung auf dem Bildschirm beim Ausdruck der
Zusammenhang von Text und zugehörigem Bild verloren geht.

• 

Wird der Fehler nicht bemerkt, besteht die Gefahr, daß Arbeiten nicht korrekt
durchgeführt werden und es dadurch zu Personen- und Sachschäden kommt.

• 

→ Vergleichen Sie deshalb nach dem Druckvorgang unbedingt die Ausdrucke mit der
Bildschirmdarstellung. Korrigieren Sie die Ausdrucke im Fehlerfall so, daß der Inhalt der
Bildschirmdarstellung zutreffend wiedergegeben wird.

WARNING

Danger of losing text-figure correspondence when printing out.

For technical reasons, it can currently not be ruled out that the correspondence
between text and associated figure can be lost when it is printed out, even though
the display on the screen is correct.

• 

If the fault is not noticed, there is the danger that work will not be performed
correctly which can cause injury and damage.

• 

→ Therefore, always compare printouts with the screen display after printing them out. Correct
the printouts if they are faulty so that the content of the screen display matches that on the
printouts.

AVERTISSEMENT

Risque de perte de la correspondance texte-illustration lors de l'impression papier.

Pour des raisons techniques, il ne peut pas être exclu à l'heure actuelle que, même
en cas d'affichage correct à l'écran, la correspondance entre le texte et l'illustration
puisse être erronée sur l'impression papier.

• 

Si l'erreur passe inaperçue, on court le risque d'exécuter certaines opérations de
manière incorrecte pouvant conduire à des dommages corporels et matériels.

• 

→ Comparez impérativement pour cette raison les impressions papier avec l'affichage à l'écran.
Corrigez-les en cas d'erreur de manière à reproduire correctement l'affichage à l'écran.

ATTENZIONE

Pericolo di perdita dell'abbinamento testo-immagine nella stampa.

Per motivi tecnici non è escluso che, nonostante la rappresentazione sullo schermo
risulti perfetta, durante la stampa venga persa la corrispondenza fra testo e
relativa immagine.

• 

Se tale difetto non viene rilevato vi è il pericolo che i lavori non siano eseguiti
correttamente; ciò può avere come conseguenza lesioni e danneggiamenti.

• 

→ Per questo motivo, dopo la stampa è assolutamente necessario confrontare le stampe con la
rappresentazione sullo schermo. In caso di errore si prega di correggere le stampe, così da
garantire la riproduzione esatta della rappresentazione sullo schermo.

Diagnostic system: reading out fault memory and activating systems

Subsequent work

2200

 

 

 

 

 

 

 

Content   ..  508  509  510  511   ..