Porshe 911 (997). Manual - part 508

Installation location of front mount

Installing centring journal

1. Position centring journal -2- with support -2A- on the hardtop body -3- and screw down fastening

screws -1- . Tightening torque → Tightening torque: 10 (7.5 ftlb.) Nm

Installing convertible-top peg mount

Installation Location:

Diagnostic system: reading out fault memory and activating systems

Installing centring journal (hardtop)

2189

Installation position of convertible-top peg mount

Installing convertible-top peg mount

1. Place convertible-top peg mount -1- on windscreen frame from below -arrow A- , position it correctly

and screw down hand-tight using the fastening screws -2- .

2. To position convertible-top peg mount, close convertible top or fit

hardtop.

3. Move convertible-top peg mount as far as possible outwards (towards the centring journal)

-arrow B-

 and screw down. Tightening torque → Tightening torque: 10 (7.5 ftlb.) Nm

4. Position cap -3- from below -arrow C- and clip into place.

Subsequent work

Subsequent work

1. End service position. → 6101IN IN -Convertible top in service

position

2. Check gap dimensions for convertible top, adjust if necessary.→ 501000  Diagram - body gap dimensions

Diagnostic system: reading out fault memory and activating systems

Installing convertible-top peg mount

2190

Note

Only for vehicles with hardtop.

3. Install hardtop. → 610219 Removing and installing hardtop - section on "Installing"

Note

Only for vehicles with hardtop.

4. Adjust hardtop. → 610215 Adjusting hardtop - section on "Adjusting"

Subsequent work

Subsequent work

Note

Only for removing/installing or replacing convertible-top peg mount.

1. Install sun visor. → 682319 Removing and installing rear window - section on

"Installing"

997310, 997311, 997320, 997321, 997610, 997611, 997620, 997621

WARNUNG

Gefahr des Verlusts der Text-Bild-Zuordnung beim Ausdruck.

Aus technischen Gründen kann derzeit nicht ausgeschlossen werden, dass trotz
einwandfreier Darstellung auf dem Bildschirm beim Ausdruck der
Zusammenhang von Text und zugehörigem Bild verloren geht.

• 

Wird der Fehler nicht bemerkt, besteht die Gefahr, daß Arbeiten nicht korrekt
durchgeführt werden und es dadurch zu Personen- und Sachschäden kommt.

• 

→ Vergleichen Sie deshalb nach dem Druckvorgang unbedingt die Ausdrucke mit der
Bildschirmdarstellung. Korrigieren Sie die Ausdrucke im Fehlerfall so, daß der Inhalt der
Bildschirmdarstellung zutreffend wiedergegeben wird.

Diagnostic system: reading out fault memory and activating systems

Subsequent work

2191

WARNING

Danger of losing text-figure correspondence when printing out.

For technical reasons, it can currently not be ruled out that the correspondence
between text and associated figure can be lost when it is printed out, even though
the display on the screen is correct.

• 

If the fault is not noticed, there is the danger that work will not be performed
correctly which can cause injury and damage.

• 

→ Therefore, always compare printouts with the screen display after printing them out. Correct
the printouts if they are faulty so that the content of the screen display matches that on the
printouts.

AVERTISSEMENT

Risque de perte de la correspondance texte-illustration lors de l'impression papier.

Pour des raisons techniques, il ne peut pas être exclu à l'heure actuelle que, même
en cas d'affichage correct à l'écran, la correspondance entre le texte et l'illustration
puisse être erronée sur l'impression papier.

• 

Si l'erreur passe inaperçue, on court le risque d'exécuter certaines opérations de
manière incorrecte pouvant conduire à des dommages corporels et matériels.

• 

→ Comparez impérativement pour cette raison les impressions papier avec l'affichage à l'écran.
Corrigez-les en cas d'erreur de manière à reproduire correctement l'affichage à l'écran.

ATTENZIONE

Pericolo di perdita dell'abbinamento testo-immagine nella stampa.

Per motivi tecnici non è escluso che, nonostante la rappresentazione sullo schermo
risulti perfetta, durante la stampa venga persa la corrispondenza fra testo e
relativa immagine.

• 

Se tale difetto non viene rilevato vi è il pericolo che i lavori non siano eseguiti
correttamente; ciò può avere come conseguenza lesioni e danneggiamenti.

• 

→ Per questo motivo, dopo la stampa è assolutamente necessario confrontare le stampe con la
rappresentazione sullo schermo. In caso di errore si prega di correggere le stampe, così da
garantire la riproduzione esatta della rappresentazione sullo schermo.

ADVERTENCIA

Al imprimir se corre el riesgo de perder la correcta asignación de las figuras al texto.

Por motivos técnicos, por el momento no se puede descartar que, aun siendo
correcta la imagen que aparezca en la pantalla, al imprimir se pierda la
correlación entre el texto y la figura correspondiente.

• 

Si este error pasara desapercibido, existe el riesgo de que los trabajos no se
ejecuten de forma correcta y, por tanto, se produzcan daños personales y

• 

Diagnostic system: reading out fault memory and activating systems

Subsequent work

2192