|
|
Removal Removing rear disc brake pads Removing retainer pin 1. Remove the safety bracket and extract the retainer pin inwards -arrows- . 2. Pull out the warning contact wire on the brake calliper and remove the warning contacts from the brake pad plates. 3. Remove brake pads using the brake pad puller. Always observe the following important points: Press the brake pads back as far as possible using the piston resetting fixture. Installation Installing rear disc brake pads WARNING Risk of accidents if brake pads with the wrong brake pad quality are installed. This can result in longer braking distances and more wear. • Diagnostic system: reading out fault memory and activating systems Removal 1285 |