Porshe 911 (997). Manual - part 190

 

  Index      Hummer     Porshe 911 997 series - service repair manual 2004-2008 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  188  189  190  191   ..

 

 

Porshe 911 (997). Manual - part 190

 

 

Cross member

1. Remove the cross member

Coolant hose to the transmission

2. Dismantle the coolant hoses and container

Electric plug for reversing light switch

3. Disconnect the electrical connection for the reversing light switch.

Connection of B+ to the transmission

Diagnostic system: reading out fault memory and activating systems

Dismantling

917

4. Remove the electric cable (positive lead). Do this by removing the container from the transmission

-arrows-

 and disconnecting the lead in the B-Plus box -1- .

Removing shift and selector cables

5. Disconnect shift -1- and selection cables -2- from the transmission.

Drive shaft

Note

Protect drive shafts against mechanical damage (e.g. with a rubber hose which has been cut open).

6. Remove drive shafts on transmission side. To do this, unscrew the six Allen screws joining each

drive shaft and transmission flange. In order to stop the wheel being pulled round, it should be held
still.

Clutch line

7. Disconnect hydraulic line for clutch control. Collect emerging brake fluid in a suitable container. Seal

open lines with suitable plug.

Diagnostic system: reading out fault memory and activating systems

Dismantling

918

Removing transmission

Retaining device

1. Unscrew fastening screws between stabiliser and engine mount, screw holding device P 9624/2

to stabilizer-engine mount, turn spindle upwards and support engine.

2. Place transmission jack under transmission and fasten fixing

strap.

Transmission container

3. Remove transmission container.

Transmission support

4. Remove transmission support.

Diagnostic system: reading out fault memory and activating systems

Removing transmission

919

Connecting screws

Note

The transmission can be lowered by a maximum of 25 mm to improve accessibility.

5. Unscrew fastening screws (8) between engine and transmission.

6. Move the transmission out downwards and towards the front by lowering the transmission jack step by

step.

Installing transmission

Installing transmission

Note

Before installing the transmission, clean splines of transmission input shaft and grease lightly, e.g. with Olista
Longtime 3 EP.

Note

When positioning the transmission, make sure that the dowel sleeves are in the correct position in the
crankcase.

Diagnostic system: reading out fault memory and activating systems

 Installing transmission

920

 

 

 

 

 

 

 

Content   ..  188  189  190  191   ..