Porshe 911 (997). Manual - part 186

Removing shift console

Removing gearshift bracket

Fitting locking bridge

1. Locking bridge P 9619/1 must be fitted on the gearshift

bracket.

Opening bayonet lock

2. Open bayonet locks on the pre-selector and shifting connections.

Disengaging shift cables

3. Disengage adjustment pin on pre-selector and shifting connections.

Diagnostic system: reading out fault memory and activating systems

 Removing shift console

901

Unclipping supports

4. Unclip supports on the gearshift bracket.

Removing gearshift bracket

5. Unscrew nut and lift gearshift bracket up and off.

Removing locking bridge

6. Remove locking bridge.

Installing shift console

Diagnostic system: reading out fault memory and activating systems

Removing gearshift bracket

902

Installing gearshift bracket

Installing gearshift bracket

1. Fit gearshift bracket and screw in

nuts.

Location

Explanation

Type

Basic value

Tolerance 1

Tolerance 2

Gearshift bracket

Tightening torque

10 (7.5 ftlb.) Nm

Fitting locking bridge

2. Locking bridge P 9619/1 must be fitted on the gearshift

bracket.

Diagnostic system: reading out fault memory and activating systems

Installing gearshift bracket

903

Clipping in supports

3. Clip in supports on the gearshift bracket. The support with the blue hinged tube must be fitted on the left

and the support with the black hinged tube must be fitted on the right.

Engaging shift cables

Note

Before starting to install the gearshift bracket, ensure that the transmission is in neutral.

4. Engage adjustment pin on pre-selector and shift connections.

Closing bayonet locks

5. Close bayonet locks on the pre-selector and shift connections.

Diagnostic system: reading out fault memory and activating systems

Installing gearshift bracket

904