|
|
Content .. 1077 1078 1079 1080 ..
Pushing the ABS wire harness inward 5. Push the ABS wire harness inward -arrow- . Stick rubber sleeve together. Note Only for vehicles with HBA. 6. Cut through the rubber sleeve -a- and insert the HBA line -arrow A- . Stick the rubber sleeve together at the cut edge -a- using a commercially available PUR adhesive and seal. Press the rubber seal into the Crimping lines Note Select a place for the joint where there is enough space to join all the lines present. Diagnostic system: reading out fault memory and activating systems Installing rear ABS wire harness 4473 |