|
|
Subsequent work WARNING Coolant is hazardous to health Irration of skin • → Wear protective gloves and goggles → In case of contact with the skin or eyes, wash immediately with plenty of water! Note In order to facilitate assembly of coolant pipes and hoses smear with Klüber Syntheso Glep or alternatively 1. Fit coolant hose. 2. Install engine carrier → 103019 Removing and installing engine carrier - chapter on "Installing". → Tightening torque: 65 (48 ftlb.) Nm . → Tightening torque: 10 (7.5 ftlb.) Nm 3. Move transmission jack from work area. 5. Fit drive belt → 137819 Removing and installing drive belt - chapter on "Installing". 6. Install air cleaner housing → 242519 Removing and installing air cleaner housing - chapter on 7. Fill coolant and bleed system → 193817 Draining and filling coolant - chapter on "Filling". 8. Perform a test drive, adjusting the coolant level in the container if necessary (note minimum/maximum marking). 997110, 997111, 997120, 997121, 997310, 997311, 997320, 997321, 997410, 997411, 997430, 997431, WARNUNG Gefahr des Verlusts der Text-Bild-Zuordnung beim Ausdruck. Aus technischen Gründen kann derzeit nicht ausgeschlossen werden, dass trotz • Wird der Fehler nicht bemerkt, besteht die Gefahr, daß Arbeiten nicht korrekt • Diagnostic system: reading out fault memory and activating systems Subsequent work 577 |