Porshe 911 (997). Manual - part 1043

 

  Index      Hummer     Porshe 911 997 series - service repair manual 2004-2008 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  1041  1042  1043  1044   ..

 

 

Porshe 911 (997). Manual - part 1043

 

 

Installing mounting saddle for rear-seat backrest

2. Install mounting saddle for rear-seat backrest.

2.1. Position mounting saddle for rear-seat backrest -2- and secure with the two fastening screws -1- .

→ Tightening torque: 10 (7.5 ftlb.) Nm

Engaging the support

3. Install left and right support.

3.1. Position the support and engage in lower side member.

Securing the support

3.2. Push in the locating peg -1- of the support and check that it is seated correctly.

3.3. Tighten the fastening nuts -3- and fastening screws -2- . → Tightening torque: 7.2 (5.5 ftlb.)

Nm

4. Lay the floor covering over the support and

engage.

Note

Ensure that belt strap can run properly!

Diagnostic system: reading out fault memory and activating systems

Completing the vehicle

4329

Installing seat belt and fitting

5. Secure seat belt mount at left and right.

5.1. Screw in fastening screw -2- , seat belt and fitting -3- and spacer sleeve -4- on inner lower side

member. → Tightening torque: 50 (37 ftlb.) Nm

5.2. Press in cap -1- .

Installing lateral footwell trim on driver's side

6. Install left footwell trim panel.

6.1. Insert footwell trim panel -3- ( -arrow A- ) and screw in the three fastening screws -2- . →

Tightening torque: 3 (2 ftlb.) Nm

6.2. Insert the fuse carrier cover -1- with both clips -4- into the lateral footwell trim panel -2- and clip in

-arrow B-

 .

Installing lateral footwell trim on passenger's side

7. Install right footwell trim panel.

7.1. Position footwell trim panel -3- ( -arrow A- ) and screw down with both plastic nuts -2- .

7.2. Secure floor covering -1- at the bottom in the area of the A-pillar -arrow B- .Use double-sided

adhesive tape or suitable adhesive

.

Diagnostic system: reading out fault memory and activating systems

Completing the vehicle

4330

Subsequent work

Subsequent work

Note

Only for vehicles with tyre pressure monitoring

1. Install rear wheel housing liner. → 536919 Removing and installing rear wheel housing liner -

section on "Installing" [997610 997611 997620 997621]→ 536919 Removing and installing rear
wheel housing liner - section on "Installing" [997310 997311 997320 997321]

2. Install rear underbody cover. → 519419 Removing and installing rear cover - section on "Installing"

3. Install reservoir. → 194019 Removing and installing reservoir - section on "Installing"

4. Install air cleaner housing. → 242519 Removing and installing air cleaner housing - section on "Installing"

5. Install rear spoiler. → 635519 Removing and installing rear spoiler - section on

"Installing" [997310 997311 997610 997611]→ 635519 Removing and installing rear spoiler -
section on "Installing" [997320 997321 997620 997621]

6. Install rear light at left and right. → 943119 Removing and installing rear light - section on "Installing"

7. Install auxiliary brake light. → 947019 Removing and installing auxiliary brake light - section on

"Installing"

Note

Only in the cabriolet.

8. Install roll-over bar. → 697219 Removing and installing roll-over bar - section on

"Installing" [997610]→ 697219 Removing and installing roll-over bar - section on "Installing" [997310
997311 997320 997321 997611 997620 997621]

Note

Only in the cabriolet.

9. Install frame for roll-over protection system. → 697719 Removing and installing frame for roll-over

protection system - section on "Installing"

Note

Only in the cabriolet.

10. Install frame for roll-over protection system. → 697719 Removing and installing frame for roll-over

protection system - section on "Installing"

11. Install relay carrier. → 979019 Removing and installing relay carrier - section on "Installing"

12. Install trim panel for seat well. → 702919 23 Removing and installing trim panel for seat well - section on

"Installing"

Diagnostic system: reading out fault memory and activating systems

 Subsequent work

4331

13. Install rear wall trim panel → 703119 Removing and installing trim panel for rear wall - section on

"Installing" [997310 997311 997320 997321]→ 703119 23 Removing and installing trim panel for rear
wall - section on "Installing" [997610 997611 997620 997621]

Note

Only in the coupé.

14. Install C-pillar trim panel. → 706819 23 Removing and installing C-pillar trim panel - section on

"Installing"

15. Install rear side trim panel at left and right. → 707519 Removing and installing rear side trim panel -

section on "Installing"

16. Install left and right scuff plate. → 680519 Removing and installing inner door sill trim - section on

"Installing"

17. Install front seat at left and right. → 720119 Removing and installing front seat - section on

"Installing" [997310 997320 997610 997620]→ 720119 Removing and installing front seat -
section on "Installing" [997311 997321 997611 997621]

18. Carry out work instructions after disconnecting the battery. → 271000  Work instructions after

disconnecting the battery

997310, 997311, 997320, 997321, 997610, 997611, 997620, 997621

WARNUNG

Gefahr des Verlusts der Text-Bild-Zuordnung beim Ausdruck.

Aus technischen Gründen kann derzeit nicht ausgeschlossen werden, dass trotz
einwandfreier Darstellung auf dem Bildschirm beim Ausdruck der
Zusammenhang von Text und zugehörigem Bild verloren geht.

• 

Wird der Fehler nicht bemerkt, besteht die Gefahr, daß Arbeiten nicht korrekt
durchgeführt werden und es dadurch zu Personen- und Sachschäden kommt.

• 

→ Vergleichen Sie deshalb nach dem Druckvorgang unbedingt die Ausdrucke mit der
Bildschirmdarstellung. Korrigieren Sie die Ausdrucke im Fehlerfall so, daß der Inhalt der
Bildschirmdarstellung zutreffend wiedergegeben wird.

WARNING

Danger of losing text-figure correspondence when printing out.

For technical reasons, it can currently not be ruled out that the correspondence
between text and associated figure can be lost when it is printed out, even though
the display on the screen is correct.

• 

If the fault is not noticed, there is the danger that work will not be performed
correctly which can cause injury and damage.

• 

Diagnostic system: reading out fault memory and activating systems

Subsequent work

4332

 

 

 

 

 

 

 

Content   ..  1041  1042  1043  1044   ..