Porshe 911 (997). Manual - part 1004

→ Per questo motivo, dopo la stampa è assolutamente necessario confrontare le stampe con la
rappresentazione sullo schermo. In caso di errore si prega di correggere le stampe, così da
garantire la riproduzione esatta della rappresentazione sullo schermo.

ADVERTENCIA

Al imprimir se corre el riesgo de perder la correcta asignación de las figuras al texto.

Por motivos técnicos, por el momento no se puede descartar que, aun siendo
correcta la imagen que aparezca en la pantalla, al imprimir se pierda la
correlación entre el texto y la figura correspondiente.

• 

Si este error pasara desapercibido, existe el riesgo de que los trabajos no se
ejecuten de forma correcta y, por tanto, se produzcan daños personales y
materiales.

• 

→ Por ello le rogamos que tras el proceso de impresión compare siempre las copias impresas con
la imagen de la pantalla. En caso de error, corrija las copias impresas de forma que se
correspondan con el contenido de la imagen de la pantalla.

Diagnostic system: reading out fault memory and activating systems

Installing luggage compartment light

4173

- Removing bulb for engine compartment light
- Installing bulb for engine compartment light

Removing bulb for engine compartment light

Removing engine compartment light

ATTENTION

Danger of damage to property if bulbs are used or handled incorrectly!

Risk of damage to bulbs and bulb housing.

• 

→ Switch off ignition and remove ignition key.

→ To prevent short circuits, the load in question must be switched off while changing bulbs.

→ Only bulbs specified in the bulb table may be used.

→ Bulbs with a higher wattage may damage the bulb housing.

→ New bulbs must be clean and free of grease. Therefore, never touch the bulbs with your bare hands.

Use a cloth or soft paper when changing bulbs.

→ In certain states, it is compulsory to carry spare light bulbs.

Installation Location:

4174

Engine compartment light overview

H

- Engine compartment light

Disengaging wiring harness on blower motor housing

1. Disengage wiring harness on blower motor housing.

Removing engine compartment light

2.

Diagnostic system: reading out fault memory and activating systems

Removing engine compartment light

4175

Press engine compartment light carefully out of the blower motor housing at the cutout -arrow- using a
screwdriver.

3. Pull off plug on engine compartment light and remove engine compartment

light.

Removing bulb for light

Removing bulb for light

1. Remove defective bulb from between the contact springs.

Installing bulb for engine compartment light

Installing bulb for light

Note

Only use the relevant bulb specified in the bulb table →  IN IN - Bulb table and installation instructions -
"Information" chapter.

Diagnostic system: reading out fault memory and activating systems

Removing bulb for light

4176