|
|
Toothed segment 9538/1 Note The toothed segment 9538/1 must be bored to ø 15 mm to guarantee a perfect fit and to avoid damaging the 1. To counter, fit toothed segment 9538/1 to the crankcase using an M12 x 50 hexagon-head bolt (fine thread). Detaching drive plate 2. Loosen and unscrew eight M10 x 25 fastening screws on the drive plate. Remove drive plate. 3. Loosen fastening screw for toothed segment. Installing drive plate for converter Installing drive plate for converter 1. Position drive plate on the crankshaft's dowel pin and press on to the crankshaft flange. Insert all M10 x 25 fastening screws (8). 2. Align toothed segment 9538/1 and tighten fastening screw again. 3. Screw in and tighten fastening screws in diagonally opposite sequence. → Initial tightening: 25 (19) Nm (ftlb.) ; → Final tightening - torque angle: 120 ° 4. Remove toothed segment. Diagnostic system: reading out fault memory and activating systems Removing drive plate for converter 321 |