|
|
Flywheel, 3.6 l 2. Loosen and unscrew fastening screws on flywheel. Carefully take off flywheel (watch the thread!). Undo fastening screw for toothed segment. Note Check the friction surface of the flywheel. The flywheel must be replaced if it is damaged or discoloured. 3. Inspect the friction surface of the flywheel visually. Installing double-mass flywheel Installing double-mass flywheel Note Before re-installation, clean the friction surface of the flywheel with a clean lint-free cloth that has been 1. Position double-mass flywheel on the crankshaft's dowel pin and press on to the crankshaft flange. Insert all fastening screws (8). 2. Align toothed segment 9538/1 and tighten fastening screw again. 3. Screw in and tighten fastening screws in diagonally opposite sequence. → Initial tightening: 19 ftlb. ; → Final tightening - torque angle: 120 ° 4. Remove toothed segment. Subsequent work Subsequent work for double-mass flywheel 1. Install clutch → 305019 Removing and installing clutch - chapter on 2. Install manual transmission → 343519 Removing and installing transmission - chapter on "installing" [997410 997411 997610 997611]→ 343519 Removing and installing transmission - chapter on Diagnostic system: reading out fault memory and activating systems Installing double-mass flywheel 317 |